The nuts and lock washers needed to install a 7 inch brake assembly to the brake mounting flange is part
# BRKH7 which includes enough hardware for 2 brake assemblies.
I'm not certain what you mean by 'drum without a hub'. If you're talking electric drum brakes, the 7 inch hub drums we offer are one integrated piece like # AKHD-545-2-2K which uses the L44649 inner/outer bearing or
# AKHD-545-2-1K which is compatible with the L44643 inner/outer bearing.
If instead you meant to say you... view full answer...
The fitting you need is a type 1 like the MB Sturgis Propane Hose w/ Back Check - Type 1 x 1/4" MPT - 20" # 100473-20-MBS. As far as the regulator, I recommend the Camco Vertical 2-Stage Propane Regulator - 160,000 Btu/Hr # CAM59313. If you need the supply hose, that is the # 37207-31255. It is important to note that this supply hose is for the standard 3/8" male fitting on the manifold. view full answer...
We always recommend going with 10 Gauge Wire # 10-1-1 for the electric brakes. Technically 12 Gauge should work but since the wiring has to run a ways we go with the mindset that a slightly larger wire might possibly let a little more power through and give you a better connection.
You'll want to use heat shrink butt connectors # DW05745-10 for this installation. view full answer...
The Lippert 126003 is a 3,500 pound hub/drum and has a bolt pattern on 5 on 4-1/2 inches. The Trailer Hub and Drum Assembly # AKHD-545-35-K will be the replacement you will need.
The hub and drum has an Inner Bearing # L68149 and an Outer Bearing # L44649. The bearings, races, grease seals, grease caps, and lug nuts are included. The hubs bearings on your trailer should be repacked and replaced every 12 months or at 12,000 miles whichever one comes first.
The Electric Trailer Brake... view full answer...
The only tandem axle lift kit available is the Correct Track Trailer Alignment and Lift Kit - Tandem Axle item # RR23QX. It is comparable to the Lippert system and will raise your 2021 K-Z Sportsmen Travel Trailer trailer height by 1-1/4" or 2-1/4".
If your axles are above your leaf springs you can always use an axle flip kit to gain 2"-3" of lift depending on how thick your axle is. If you have a 2-3/8" axle you will want the Dexter Trailer Springs Over-Under Conversion Kit item # K71-384-00.... view full answer...
Go To Results